Plugin manager
From LimeSurvey Manual
General
LimeSurvey supports at the moment the following plugins:
- auditlog:
- export results to R:
- extendStartpage:
- LDAP:
- LimeSurvey internal database:
- oldUrlCompat:
- QuickMenu:
- STATA Export:
- Webserver:
Auditlog
Export results to R
ExtendStartpage
LDAP
By activating this plugin, you can perform basic authentication against an LDAP server. Make sure your PHP configuration has LDAP support enabled.
Enabling and configuring settings for plugin AuthLDAP v2.05+:
- Enable LDAP in PHP.INI.
- Verify that phpinfo.php shows that LDAP is enabled.
- The location of LimeSurvey's built-in phpinfo.php is: Upper Right Menu -- Configuration -- Settings -- Global Settings. Then, below the table, you will have a link for "Show PHPInfo".
- Go to LimeSurvey Plugin Manager.
- Configure LDAP plugin.
LimeSurvey internal database
This plugin is the default and can not be disabled. It uses the built in LimeSurvey database. It is a fall-back mechanism so that you can always login to the installation when needed.
OldUrlCompat
QuickMenu
STATA export
Webserver
This plugin leaves authentication to the webserver and reads the result from a configurable server setting. This method has been around for a while, and was configured from config.php. If you used this authentication, you should enable the plugin in the plugins menu and move your configuration from config.php to the plugin's settings. Feel free to contact the team via the bugtracker or irc-channel if it no longer functions the way it did before.
FAQ
Developing another authentication plugin
If you want to extend or develop your own authentication plugin, please read our whole wiki on this topic - authentication plugin development.